Transistor-Fluorescent Light

Indoor fluorescent light with two tubes for fixed installation. On/off switch with 2 brightness settings (tube 1 or tube 1 +2 can be selected). The tubes are covered with a clear coating.

• Voltage: 12 volts
• Connection: 2-strand wire with cigarette lighter plug
• Power consumption: 0.5/0.9 Amps
• Output: 2 x 8 Watt
• Dimensions: L 355 x H 40 x W 60 mm
• Distance between fixing holes: 200 mm

Note:
The light can be connected to a 12 volt on board system. This unit doesn't have polarity protection.
Manufacturer produced connecting lines are made with different colors or codes, therefore general polarity indication isn't evident.

The correct polarity connection is achieved by following these steps:

1. Unscrew the cigarette lighter plug
2. Check the markings and colors of the connecting lines
3. The leading middle contact connecting line is POS 12 volt.

Look over the directions/short manual.

Don't forget to install a fuse on the POS-wire.