Marine Toilets
Electrical or manual toilet - Which is right for you?
Toilets on board often require getting used to and differ considerably in their handling and functioning from household toilets. In the following description, we will give you a few tips for the proper selection and installation of your new marine toilet.
Toilets on board often require getting used to and differ considerably in their handling and functioning from household toilets. In the following description, we will give you a few tips for the proper selection and installation of your new marine toilet.
QUIET FLUSH Marine Toilet / Compact Basin / Seawater Pump
-28%
QUIET FLUSH Marine Toilet / Seawater Pump
-27%
Board Toilet QUIET FLUSH / Comfort / Seawater Pump / Soft-close Lid
-27%
JABSCO
Board Toilet QUIET FLUSH / Comfort / Seawater Pump / Soft-close Lid
569.95
EUR
€780.64
from €569.95
QUIET FLUSH Compact Marine Toilet / Magnetic Valve
Board Toilet QUIET FLUSH / Comfort / Magnetic Valve / Soft Close Lid
Electric Board Toilet / Comfort with Soft-close Lid
-11%
SEALOCK Replacement Pump for Marine Toilets
69 - Spare Sealing Ring for Bottom Part
RM
69 - Spare Sealing Ring for Bottom Part
12.95
EUR
only €12.95
69 - Spare Handle for Piston Rod
-12%
Hinge cover set for marine toilets in standard size
JABSCO
Hinge cover set for marine toilets in standard size
13.95
EUR
only €13.95
Service Kit for LAGUNA On-Board Toilet
Electric Button for On-Board Toilet
-8%
Repair Kit for SEALOCK On-Board Toilet
RM
Repair Kit for SEALOCK On-Board Toilet
39.95
EUR
only €39.95
Spare Parts Kit for PAR New Style (YoM 1997-2007) / SPLASH
-36%
JABSCO
Spare Parts Kit for PAR New Style (YoM 1997-2007) / SPLASH
38.95
EUR
€61.29
only €38.95
Spare Parts Kit for Hand Pump (starting YoM 2007)
JABSCO
Spare Parts Kit for Hand Pump (starting YoM 2007)
45.95
EUR
only €45.95
Original hand pump for PAR on-board toilet
Replacement Lid + Seat / NEW STYLE Normal
-8%
Replacement cover + seat / NEW STYLE comfort
-9%
Hand pump for SPLASH on-board toilet
MATRO
Hand pump for SPLASH on-board toilet
89.95
EUR
only €89.95
Mounting kit for portable toilets
-16%
Spare Seal for Lid and Seat / Popular Toilet
LAVAC
Spare Seal for Lid and Seat / Popular Toilet
37.95
EUR
only €37.95
Spare Pump Lower-Deck / Popular Toilet
PURYTEC Water Additive / refill pack
YACHTICON
PURYTEC Water Additive / refill pack
8.95
EUR
only €8.95
Marine Toilets
Installation Site - What to Consider?
Above the waterline:
The inlet hose allows for the most direct route from the inlet seacock to the flushing pump inlet nozzle. A non-return valve next to the inlet seacock ensures that the pump remains suctioned after each use. The discharge hose from the discharge elbow pipe is installed in such a manner that it creates a loop, where the highest point is located at least 30 cm (12") above the elbow pipe. With the assembly of a gooseneck valve at the highest point of the hose loop, you can be reassured that any water from the toilet system will remain where it is meant to be and will not overflow. This applies both to overboard disposal and flow into the holding tank when the discharge elbow pipe is located above the collection tank. Should the tank be installed so that it is located above the elbow, a vented loop must be used.
Electric toilet below the waterline:
With an electric toilet, which is installed below the water line, you have the option to install a vented loop between the inlet seacock and the irrigation pump. This is normally not possible, as this would prevent the suction of the flushing pump, but with the mounting of a solenoid valve on the gooseneck, this mounting arrangement can be achieved. When you press the flush motor, the solenoid valve of the gooseneck closes and water can be sucked through the gooseneck. Upon releasing the flush button, the aeration valve is opened again and the siphon effect is stopped.
Below the waterline:
The inlet hose and outlet hose should be installed in a manner that they form a loop that prevents a siphoning effect, with a highest point of at least 20 cm (8") higher than the waterline. At the highest point, an aerated gooseneck valve must be installed. The ends of all hoses can be secured with two worm hose clamps made out of stainless steel.
Caution: If the toilet rim is located less than 20 cm (8") above the waterline while the boat is at a standstill, or if there is any chance that the waterline from the toilet could rise higher and spill outwards, pipeline must be installed through the thru-hull fittings, and a vented loop must be installed, regardless of whether it is an inlet or outlet.