Usable in many areas
Plywood panels are - because of their specific strength - ideal for the interior of ships. They consist of at least three layers of glued wood. Because of the grain and the method of gluing, directional properties of this material, such as the swelling behavior, are consistent over the entire plate.
We offer excellent, high quality marine plywood with decorative veneer in four different types of wood and in two different qualities, also finest teak plywood with 2.5 mm veneer or Okumé plywood AW100 for the interior design.
We provide decorative veneers in the following qualities: A/B: usable on both sides and A/C: usable one-sided. Quality A: best quality, even colouring, fine structure. Quality B: good quality, slight colour variations and structural changes allowed.
Exactly to your needs!
You can saw plywood excellently into different sizes. Please send us the datasheet for plywood filled with your specific data.
Plywood in various designs and qualities
You can choose between four different decorative veneers: Sapeli Mahogany, Teak, Cherry or Khaya Mahagony, each in the quality A/B or A/C.
We provide these plywood panels, depending on quality, in thicknesses from 2 to 12 mm or from 6 to 15 mm. We also offer finest Teak plywood with 2.5 mm veneer of quality A/B, which is ideal for table tops, work surfaces and for teak decks. By request we provide this stronger material also with milled grooves.
Okumé for interior design
Our high-quality Okumé plywood is AW100 glued and consists throughout of Okumé. This plywood is ideal for the interior design of your boat. You can use it for example for floors, partitions, bunk boards, etc.
SVB helps you to realize your projects!
Your idea is in good hands with us - no matter the project you have in mind, SVB has competent planning assistance and the right service to realise all your individual ideas.
Don't hesitate to contact us: 0049 (0) 421 57290 - 0
Panel and cutting sizes
We offer a free cutting of the panels according to your idea.
The purchase occurs only for whole plates or in the formats specified on the left. Please note that the cutting width is 3-4 mm.
The panel saw
We offer a free cutting of the panels according to your idea. With our panel saw it is possible to perform horizontal or vertical cuttings. The purchase occurs only for whole plates or in the formats specified below. Please note that the cutting width is 3-4 mm. With our panel saw we can cut accurate. It is possible to cut the complete panel horizontal or vertical.
Besides Perspex cuttings we offer customized plywood cuttings.