Mark B.'s SVB Skipper Profile
This profile is set to private.
Mark B. asked these questions
1
A question about:
Replacement Installation Box for Mixing Set
Mark B.
on Oct 29, 2019
Hi, do you know if these replacement mixer box and shower boxes (Except for cutting bigger holes) are a direct replacement for the other type with the strapped lid cover its for a cruiser 33??
Answers:
Philip W. answered
on Oct 30, 2019
I used this box to replace the “strap cover type”. My particular mixer tap was not directly compatible with the new box. I had to make up some large washers to get it to fit correctly. My mixer tap has a “T” pull and twist handle. This is quite a tight fit within the box so it is difficult to get your fingers under to pull. I have installed a small pull chord to facilitate operation. I guess that there are several models of mixer tap so this might not be the case in your installation.
Mark B. answered
on Oct 30, 2019
Hi, Many thanks for your reply and I think that really answers my question however out of curiosity is your own boat a 33 cruiser?? As I take it the mixer tap would therefore be the exact same.
2
A question about:
Fuel Tank Sensor / 270 mm
Mark B.
on Mar 15, 2021
Hi I have a Bavaria 33 Cruiser and both my pedestal and lcd display panel fuel gauges are giving inaccurate readings so I presume the Road fuel sender is fault. There is a KN number on the top of the sender which is 313124 - is this the replacement sender for my boat???
Answers:
Tiberiu M. answered
on Mar 17, 2021
Hi Mark, i have purchased this fuel sender for my Bavaria 37 and did not match the existing gage on the boat . I have called the manufacture in Sweden and they were not helpful at all, they send my back to SVB. It is a volts/ohms, matching problem i am trying to fix. The manufacture did not tell me the volts/ohms range the sender works, in order to match it with the gage. i wish i would of changed it with a different system and provider !!! Good luck.
Mark B. answered
on Mar 17, 2021
Many thanks Tiberiu, the problem I have is this. The fuel tank is full for definite and the fuel gauge at the engine controls/pedestal indicates a full tank reading and the LCD read out on the control panel at the chart table indicates the fuel tank is only 35% full so not sure if it’s a sender or gauge problem or both??
Do you have any experience of this with your Bavaria 37??
Thanks again.
Tiberiu M. answered
on Mar 17, 2021
My only fuel gage at the controls/pedestal shows a constant full tank even when is 1/2 empty .