Particularly suitable for the Milwaukee cordless angle drill FRAD2
I use the adapter with the Milwaukee cordless angle drill FRAD2. with 13mm drill chuck. This machine has an enormous torque of 120NM and is particularly suitable.
The part works fine. However, you should have a very powerful cordless screwdriver. It should be 60 Newton meters. And watch out, that thing can hit back pretty hard! It's best to hold it with both hands. Otherwise there is a risk of a sprained wrist.
For sailors who are getting older ... Auxiliary system at a price quite affordable, unlike other electric cranks!
Helpful?
by Juhani N.
8/14/2020
Verified purchase
Adapter
Approximate torque need for drilling machine recommended for acouple of mast hights would be good
Helpful?
by Henning H.
6/10/2020
Verified purchase
super for turn roller furler electric
Helpful?
by Marko P.
8/8/2019
Verified purchase
Nice gadget, but not suitable for daily use.
This adapter requires a REALLY strong electric screwdriver. Used it with a 35Nm screwdriver, which I had on board, but it was much to weak - half way raising the main sail the screwdriver begun to smoke. With a 60Nm screwdriver it worked better, but you have to be very gentle on the trigger - even at slow setting the battery screwdrivers produce too many revolutions per minute. All in all i dont feel comfortable using a 300€ screwdriver in salty spray, even the best one wont last more than a season.
Hyper resistant alloy. Used with M18 BLDD2-502X Drill Driver MILWAUKEE BRUSHLESS 18V 5,0Ah 85 Nm. For a GV docéanis 411. Just pay attention to the return of the screwdriver, you have to hold it.
consistent with advertising; works well at the genoa winch level but difficult for mainsail retractor; in reality this adapter is ok but be sure that your screwdriver is powerful enough otherwise the result will be disappointing