Very nice toilet, installation is easy. It is important to note that the flushing water connection can only be made from below. The connection is so deep that it is impossible to set an angle. That is the only negative point. Easy to clean thanks to the smooth surfaces. Since the pump unit is on the inside, the toilet is quite "quiet" in comparison. Except for the somewhat unhappy flushing water connection, I can absolutely recommend the toilet.
Not easily connected to the boat's water supply. With a pressurized water system, the flushing water runs constantly. The idea is to supply water directly from outside via a sea valve. But then the flushing performance isn't exactly great. I connected it to the on-board electrical system with a solenoid valve, so it works very well. When you press the flush button, the solenoid valve opens and flushes very well. The water connection for the dishwashing water is unfortunately loosely located at the bottom and there is a risk of it bending downwards depending on the space.
Toilet is totally OK, but had new dimensions, former toilet (engine defective) had a different angle of the wall connection, other fixing points, another bowl depth, other materail strength in the wall connection area so the my existing hose was no longer to be accommodated. The problem was solved by converting the chopper / motor unit
Great toilet, looks sleek and good quality. \ R \ nPoor that the seat is made of cheap plastic. Would have liked to have paid a few bucks more for a proper session
Helpful?
by Steven A.
3/6/2018
Ghandi could block it.
If you are the kind of guy that enjoys working on toilets then this is the toilet for you. Price is the only good thing. It is too tall, too long and the shape of the bowl is, "ineficient" for the task. The soft close seat is good but the attachment points need tightening regularly. All in all it is not suitable as a kings throne. It barely handles princess loads. Inlet pump is weak and so is outlet. Inlet point being directly under is a pain to fit and the base fixing system is a nightmare. Look underneath and you will find it looks like something they threw together out of some old parts.
The toilet is very high (with me it stands on a pedestal) The toilet did not pumte off. So I talked to Herr Ludwig about that. He told me that my cable (4Q) would not be enough but it should be 16 Q. All of my clubmates said 16Q was very out of the ordinary. The toilet, I have again removed and installed a Manual. I think their catalog should point out this very high power requirement. I will try to sell the toilet again. Unfortunately, a small piece of porcelain is broken off when fastening. \ R \ n.
For starters, this toilet is extremely noisy, unlike advertising. Much more than the old jabsco conversion kit already very noisy and for which I had changed. Then the assembly instructions are almost non-existent. (single notice for several products, poorly translated), editing is difficult. Finally after 15 days of use, toilet clogged, probably because of an excess of toilet paper, yet special electric wc. A product of clearing marine, (mark mattchem) I insist on this point, which maintains very well my other jabsco toilet has the effect of piercing the descent ... which is in plastic, of very bad quality. To finish the service of Matro is up to the product, ie more than zero. The toilet on a boat, it's quite difficult, but with those, it's the worst.