Excellent investment considering the price. I converted one of the 2 toilets on board, and there is no photo. It's a bit noisy, but very effective. Been in place for 1 year, no issues. I will buy again with my eyes closed.
Helpful?
by Veit Ladurner F.
10/26/2021
Verified purchase
Variant:
75009
Tolle Alternative zur manuellen Toilette oder sehr teuren 12 V Optionen
This is now the second conversion kit that I bought from SVB, the first still works after two years without any problems. Despite the somewhat high background noise, I give it 5 stars due to the good quality of the material and the unbeatable price. What could possibly be changed would be the pushbutton on the control panel, the plastic on the pushbutton has come loose on me, but SVB immediately sent me a new control panel free of charge. I'm looking forward to converting my old manual toilet to 12 V -).
Conversion from Jasco Manuel to electro. Switch installed and ready. Pumps off nicely. We always press for 5 seconds, then it is pumped in and pumped out and in the break, water flows into the bowl. The process is repeated 4 times.
Helpful?
by Rautenberg K.
7/26/2021
Verified purchase
Variant:
75009
Relatively simple assembly but it still takes a big half day for it to be operational. The engine is not quiet but the manual version is not either and often, the guests do not draw enough water to rinse the pipes well. Now, with one button, it's very easy. Consider buying a 30125 - Anti siphon elbows with vent if your toilet is below the waterline. I hesitated to buy it because during the suction of the water, the anti-siphon elbow also sucks air at the same time but it works all the same. Very good purchase and very happy with the result. The most annoying thing is the replacement of the outlet pipe and the electrical wiring, but I did it, ... Good job to all
Helpful?
by Günther W.
8/21/2019
Verified purchase
Variant:
75009
Techniquement très bien. Quelques points d'attention au montage.
The kit is complete, easy to connect. The assembly with the existing bowl is done without difficulty. The sound level did not seem excessive. The feed pump is an impeller, the drain is a centrifugal pump. The original shower drain pump of my sailboat (diaphragm pump) is much noisier. I made the choice not to use the switch delivered with the kit, because of cutting necessary a little important for my taste. I used a simple push button much more discreet (a little less aesthetic perhaps) very easy to mount (simple cylindrical drilling). A remark nevertheless. If we want to hide a little different supply and exhaust tubes, it is a little obliged to mount the engine to the rear of the bowl. In this case the necessary space is not negligible. Given that the original installation of the hand pumps is done laterally with respect to the bowl (and not towards the back), I would suggest to the manufacturer of this equipment to deliver a piece of preformed tube for evacuation bringing back the customer connector rearward. If I had to mount the kit laterally to the bowl, I think I would not put a notice as good, the aesthetic would have been too degraded. The evacuation is the visible fitting on the picture published by SVB.
Helpful?
by Daniel C.
5/10/2019
Verified purchase
Variant:
75009
Real improvements (noise level, intelligent innovation on the seal between bowl and base, and efficient check valve) compared to the model of three years ago.
Helpful?
by Ingrid F.
8/14/2018
Verified purchase
Variant:
75009