The charging current distributor works perfectly. Only the installation instructions are a bit cryptic for laymen. The control needs a permanent plus. The drawing is misleading, as it is only spoken of "Ignition" here. The term "Ignition" implies a temporary impulse. In fact, that is not the case. Otherwise a good product.
Have 2 engines and 3 battery banks. Place one distributor at a time for each of the 3 battery banks and a second distributor for the other motor. Thus, highest charging reliability is given, even if a distributor fails or a motor is not running. I am very satisfied with the product. Would buy it again. To recommend!
Have the device easily install and start up. The problem that with me the controller always too fast down the stream regulated because the smaller starter battery was already full with the distributor now apparently effectively resolved. However, I can not say anything about the long-term fitness since I only did a short test.
Funktioniert jetzt gut, allerdings erst nach Austausch, erstes Exemplar war scheinbar defekt. Austausch problemlos. Anleitung zu knapp, und bezieht sich auf ein älteres Modell mit weniger Anschlüssen.
Die Einbauanleitung im Netz entspricht nicht dem Produkt. Ist aber auf der Herstellerseite dann doch zu finden. Schön wäre auch ein Kontaktbezeichnung nach Standart. Ingnition also Zündung IST doch etwas vieldeutig und hat uns viel Zeit gekostet. Jetzt funktioniert alles gut.
Bei mir war das Gerät war defekt und Reparatur dauerte sehr lang
In this case, I cannot understand the recommendation from SVB and the good ratings. The device seems quite fragile to me. My device was defective and had to be sent back to the manufacturer for repair. It took more than a month before I got the device back from the repair shop. In the meantime I have ordered a 2nd charge controller (I couldn't wait that long for the repair). The second device works, but the measured charge completion voltage is only 13.8 volts (instead of the 14.2 volts measured directly without the charge controller). So there seems to be a loss of tension for me. Next time I'll just use a simple and robust (and much cheaper) diode for charging current distribution.