SSB Ground Paint / 0.5 l
Item no.
25535
Description
SSB Ground Paint / 0.5 l
Product details
Grounding is as important as the antenna itself because it is the opposite pole of the antenna. Good transmission and reception results cannot be achieved without grounding. Steel/aluminium yachts have optimal grounding properties due to their metallic hull. Provides capacitive coupling to the seawater (capacitive grounding) regardless of any painting or antifouling present.
Grounding a GRP yacht is a major challenge. It can only be achieved by keeping the distance from the antenna tuner to the grounding surface as short as possible and having a large grounding surface. Grounding is only achieved for a short time with grounding plates, as they quickly become clogged with mussels and algae. Their effectiveness steadily decreases over time. Apply SSB-Ground-Paint on the inside of the ship below the waterline as close as possible to the antenna tuner, where it is capacitively coupled to the sea water. The area to be painted should be approx. three square metres. This means that, firstly, the ground can be connected directly behind the tuner, secondly, a large area is coupled to the seawater and thirdly, the area is protected from environmental influences and therefore maintenance-free.
SSB Ground Paint is solvent-free and can be easily applied in the abaft area under the bunks in the bilge. For protection, the surface can be painted over with conventional bilge paint. SSB-Ground-Paint is connected to the antenna tuner via a broad embedded copper strap. Coverage: 0.5 l is sufficient for approx. 3 sqm.
SSB-Ground-Paint is not protection against lightning!
Grounding a GRP yacht is a major challenge. It can only be achieved by keeping the distance from the antenna tuner to the grounding surface as short as possible and having a large grounding surface. Grounding is only achieved for a short time with grounding plates, as they quickly become clogged with mussels and algae. Their effectiveness steadily decreases over time. Apply SSB-Ground-Paint on the inside of the ship below the waterline as close as possible to the antenna tuner, where it is capacitively coupled to the sea water. The area to be painted should be approx. three square metres. This means that, firstly, the ground can be connected directly behind the tuner, secondly, a large area is coupled to the seawater and thirdly, the area is protected from environmental influences and therefore maintenance-free.
SSB Ground Paint is solvent-free and can be easily applied in the abaft area under the bunks in the bilge. For protection, the surface can be painted over with conventional bilge paint. SSB-Ground-Paint is connected to the antenna tuner via a broad embedded copper strap. Coverage: 0.5 l is sufficient for approx. 3 sqm.
SSB-Ground-Paint is not protection against lightning!
Product safety
Please note the following hazard warnings:
Hazard pictograms
Signal word
Warning
Hazard warnings
Causes skin irritation.
Causes serious eye irritation.
May damage fertility or the unborn child.
Obtain special instructions before use.
Wash … thoroughly after handling.
Wear protective gloves/protective clothing/eye protection/face protection.
IF exposed or concerned: Get medical advice/attention.
If eye irritation persists: Get medical advice/attention.
Dispose of contents/container to …
Causes serious eye irritation.
May damage fertility or the unborn child.
Obtain special instructions before use.
Wash … thoroughly after handling.
Wear protective gloves/protective clothing/eye protection/face protection.
IF exposed or concerned: Get medical advice/attention.
If eye irritation persists: Get medical advice/attention.
Dispose of contents/container to …
H315, H319, H360, P201, P264, P280, P308+P313, P337+P313, P501
Documents
Datasheet
PDF, 19,06 KB
Safety datasheet
PDF, 253,39 KB
Customers also bought
Antenna Coaxial Cable RG 58U
only
€3
11
375
LowLoss Antenna Cable ECOFLEX
only
€7
52
535
ECOFLEX PL Connector for Antenna Cable
only
€10
04
44
SEATEC
Installation Kit for SCS Pactor Modem
only
€29
37
2
Spacer / Standoff
from
€26
85
2 variants
High Voltage Cable, 6 mm²
only
€3
53
98
SCS HF Modem P4dragon DR-7400 / with Bluetooth module
only
€1.075
59
1
SCS Cable 8080 with Gender Changer
only
€31
89
7
Copper Foil 0.2 x 60 mm
only
€9
20
38
PL Connector for RG58U Cable
only
€2
48
> 100
Similar items
-6%
GARMIN
GPS24x HVS / NMEA0183 GPS Antenna
€268.07
only
€252
06
2
-40%
BANTEN
Grounding Plate, Square / 300 x 80 x 13 mm
€264.00
only
€159
62
11
-31%
BANTEN
Grounding Plate, Square / 205 x 65 x 13 mm
€145.80
only
€100
80
13
LNA-Sea-Band VOX Antenna Booster
only
€201
64
1
BNC Connector for RG58 Cable
only
€2
48
46
PL Connector for Lower Deck
only
€2
27
> 100
PL-Angle Connector
only
€4
62
37
PL Connector for RG213 Cable
only
€3
11
> 100
PL Connector for RG58U Cable
only
€2
48
> 100
RG 213 Coaxial Antenna Cable
only
€3
28
602
Customers ask customers
Ask other SVB customers who have already purchased this product from us about their experience.
Your question will be automatically forwarded to other SVB customers and published on the product page. Please do not ask any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: info@svb24.com or by phone on: +49 (0)421 57290510 .
Technical question
Question:
Gert K.
asked
on Jul 28, 2021
How do you connect the copperband to the ground paint, for the use of the copperband to the Antenna tuner.
Answer:
Dear customer, please email us at info@svb24.com with your specifications so we can connect you with a specialist.