VICTRON Color Control GX Display Remote Control

The Victron Color Control GX allows you to not only monitor your energy system by showing you all the relevant data at a glance, you can also use it to easily control all the connected devices. Data is displayed in real time and thanks to the Victron Remote Management portal you can monitor the system from anywhere in the world using an internet connection.

Intuitive Operation and Overview At a single touch of the display, the device provides instant access to all relevant information of your system, such as battery state of charge, current power consumption, power harvest from PV and power provision from mains/generator.

Remote Access
The Victron Remote Management system (VRM) provides you with full access to the extensive controls and settings of all system components that are connected to your CCGX or Venus GX. Connected to the internet, the Victron Color GX Display allows you to log in and monitor current system status, as well as perform diagnostic checks and analyse archived information from anywhere, at any time. Victron Color Control GX can be connected to the internet via its integrated ethernet interface. To connect the device to via WiFi, an optional Victron WiFi USB accessory is required.

Automatic Generator start/stop
Programme your Victron Color Control GX Display to automatically start your generator, for example by low voltage or high demand. It can also be tailored to define generator ignition times and delay starts until the end of quiet periods, for example during the night.

Supported products

• Multis and quattros, including split-phase and three-phase systems. Monitor
  and control (on/off and current limiter). Changing the configuration is possible
  (only remotely via the internet, not without an internet connection).
• BlueSolar MPPT solar chargers with one VE.Direct port.
• BlueSolar MPPT 150/70 and the MPPT 150/85 with VE.Can port.
• SmartSolar MPPT 150/70 and the MPPT 150/100 with VE.Can port. If multiple BlueSolar
  MPPTs or SmartSolar MPPTs with VE.Can are used in parallel,
  all information is combined into one.
• BMV-700 devices can be connected directly to the VE.Direct ports on the CCGX
  . Use the VE.Direct cable for this.
• BMV-600 units can be connected to the VE.Direct ports on the CCGX. An
  additional cable is required.
• Lynx Ion + shunt
• Lynx Shunt VE.Can
• Skylla-i battery chargers
• NMEA2000 tank sensors
• A USB GPS can be connected to the USB port. The display then shows the location
  and speed. The data is then sent to the VRM portal for tracking purposes. The most recent position is then displayed on the map on the VRM.
• Fronius PV inverter

Technical specifications

Operating voltage	8 - 70 V DC
Max. current consumption:	245 mA (@12 V) / 125 mA (@24 V) / 65 mA (@48 V)
Interfaces:	VE.Direct (2x) / VE.Can (2x) / CE.Bus (2x) / USB (2x) / Ethernet RJ45 (1x)
Housing dimensions:	130 x 120 x 28 mm (H x W x D)
Operating temperature range:	- 20 to + 50 °C