7 left in stock
SVB price: €67.18
You save: 11%
Excl. VAT, excl. shipping costs.
This is a NET-price excluding German VAT. Shipments to countries outside of the EU may be subject to import duties and taxes.
€67.18 This is a NET-price excluding German VAT. Shipments to countries outside of the EU may be subject to import duties and taxes.
Item no.
IEC Connector
Number of outputs
Cable length
5 m
Antenna type
24 dB
0.3 W

Product details

The omnidirectional SUPERGAIN* NOMADE DVB-T antenna is suitable for boats and vehicles of all kinds, thanks to its compact design and low weight. An integrated amplifier provides a gain of 24.5 dB. The adjustable antenna base can be screwed or glued and therefore can also be used as a cable duct under deck or in a vehicle's interior. For uneven surfaces, an inclination compensation of +/- 15° is possible.
The amplifier is located in the antenna's housing and is supplied by a 12-volt supply voltage via a 5 m coax cable. The compact dimensions and flat design of the NOMADE make the antenna very streamlined, while also allowing it to be used as an indoor antenna.
Suitable for receiving terrestrially broadcast DVB-T1 / 2, TNT and HDTV signals.
Scope of delivery: Antenna with adjustable base and 5 m coax cable, V9114PI feed-through switch including a 250mA fuse, 1.5m TV connection cable and mounting screws.

  • Dimensions: Antenna with base: Ø 245 mm x 80 mm height
  • Weight: 200 g (7 oz)
  • Material: Acrylester-styrene-acrylonitrile (ASA)
Electrical properties
  • Receiving angle: Omnidirectional, 360°
  • Polarization: Horizontal
  • Frequency range 170/890 MHz
  • Average noise: 24.5 dB
  • Noise factor: 1.7 dB
  • Impedance: 75 Ohm
  • Operating voltage: 12 V power supply
  • Current consumption: Approx. 25 mA
Antenna connection cable
  • Coax cable 3C-2V, 75 Ohm, white, 5 mm Ø, length 5 m
  • Ready for connection with F connector
  • Max. Ø F connector: 13 mm
TV connection cable
  • Coax cable 3C-2V, 75 Ohm, white, 5 mm Ø, length 1.5 m
  • Ready for connection with F- and TV- (IEC-male) connectors
  • Max. plug-Ø: F connector 13 mm / IEC connector 15 mm
Inlet switch
  • Dimensions (L x W x H): approx. 70 x 45 x 17 mm
  • F socket ANTENNA IN
  • F socket TV OUT
  • 12 V DC - two individual wires, length approx. 25 cm (RED = POS12 V (including fuse), BLACK = NEG)
  • Grounding clamp on housing (max. cable cross section: 10 mm²)
  • Fuse: 250 mA, 5 x 20 mm
  • Mounting option: a 4 mm hole
Delivery contents
  • Antenna with foot and 5 m coax cable
  • Inlet switch
  • TV connection cable: 1.5 m
  • 4x countersunk head screws: 3.5 x 16 mm
  • 4x countersunk head screws: 2.9 x 9.5 mm

Mounting instructions
  • The antenna base can be glued and / or screwed in place.
  • The 5 m coax cable runs through the antenna base.
  • If required, the TV connection cable can be extended by standard TV antenna cables (IEC / IEC connector).
  • If required, the 5 m coaxial cable can be extended. Low-loss coax cables, F connectors and plugs can be found under accessories.

Electrical connection
  • First connect the 5 m long antenna cable with the inlet switch, ANTENNA IN socket.
  • Next, connect the 1.5 m long TV connection cable to the inlet switch, TV OUT jack.
  • Connect the inlet switch to a 12 volt power source after connecting the coax cables.
  • The inlet switch has a housing terminal. This can be connected to the vehicle's body.
  • Be sure to follow the assembly sequence and avoid reverse polarity!
  • Failure to observe this can result in short circuiting, and in the worst case, total failure of the inlet switch.
  • Do not loosen / twist the screw connection of the DC voltage input!
  • The cables could break off of the circuit board, which can lead to irreparable damage.
  • Do not remove the plugs from the coaxial cables!
  • Failure to observe the above points will result in the loss of your warranty.

* GLOMEX, Italian producer of high-quality and technologically-advanced marine / automotive antennas, offers antennas under the name SUPERGAIN with new and extraordinary designs at very good price to performance ratios.


en-flag Manual
PDF, 294,66 KB

What other SVB customers have to say

100% real reviews

2 customer reviews

1.5 (out of 2 ratings)
5 Stars
4 Stars
3 Stars
by ERIC R. Flag of France 3/16/2022 Verified purchase
Product not suitable for the boat
The product is not suitable for the boat. Inefficient.
- the screws are made of galvanized steel !!!
- not enough space between the antenna and its base for easy mounting of the 4
screws fixing the antenna to its base
- mediocre performance (image freezes too often)

In short, I do not recommend
by ERIC R. Flag of France 3/4/2022 Verified purchase
je deconseille le produit
The external fixing screws of the antenna on its base, as well as the screw of adjustment of inclination of the antenna are out of galvanized steel!!! rust guaranteed in a few months, for a product intended to be installed outside a boat, this is not a guarantee of quality. The rest I haven't tested yet. We can draw prices, but there are limits. I expected from SVB a minimum of quality control of the products put in the catalogue.

Rate product

How would you rate this product?
Completely fails to meet my expectations
Only some expectations are met
Meets my basic expectations
Slightly better than my general expectations
Fully exceeds my expectations
Click on the stars to rate

Customers ask customers

Ask other SVB customers who have already purchased this product from us about their experience.

Your question will be automatically forwarded to other SVB customers and published on the product page. Please do not ask any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: or by phone on: +49 (0)421 57290510 .

No questions asked yet. Be the first to ask a question!