SUPERGAIN DVB-T 12 V Input Switch
Article Number
73781
EAN
8051566303892
Description
SUPERGAIN - Einspeiseweiche
Product details
Replacement 12 Volt input switch V9114PI for the SUPERGAIN DVB-T antennas BALLADE and NOMADE .
SUPERGAIN DVB-T antennas * are equipped with an active amplifier directly in the antenna housing. The power supply of this amplifier is from the 12 volt DC electrical system and is guided by means of the feeder via the coax cable to the antenna. At the same time, the feed path decouples the received and amplified TV radio frequency signal from the DC voltage.
* and some antennas of other manufacturers (GLOMEX, NARGUS, etc.)
Details
Hints and background knowledge
The advantage of the integrated amplifier is that weak antenna signals are already amplified directly in the antenna and can then be made available to the receiver / TV in a sufficiently high level.
If the amplifier is outside the antenna, weak signals could be additionally attenuated by line and line losses. If you then amplified these signals, the receiver / TV could no longer reliably separate the wanted signal from the noise (interfering frequencies), which would lead to picture and sound disturbances or to complete loss of reception.
Why a power supply via the coax cable?
Of course, an amplifier requires an operating voltage. Since it is possible to simultaneously carry the high-frequency antenna signal and a DC voltage on the coaxial cable, it saves the laying of an additional line for the operating voltage.
On board the unit is positioned in the area of the receiver / TV, as both are required: 12 Volt DC and the antenna signal.
SUPERGAIN DVB-T antennas * are equipped with an active amplifier directly in the antenna housing. The power supply of this amplifier is from the 12 volt DC electrical system and is guided by means of the feeder via the coax cable to the antenna. At the same time, the feed path decouples the received and amplified TV radio frequency signal from the DC voltage.
* and some antennas of other manufacturers (GLOMEX, NARGUS, etc.)
Details
- Frequency range: 40 - 2000 MHz
- Operating voltage: 12 V DC (vehicle electrical system)
- Dimensions (L x W x H): approx. 70 x 45 x 17 mm
- connections
- F jack ANTENNA IN
- F jack TV OUT
- 12 V DC - two single wires, length approx. 25 cm
RED = PLUS 12 V (including flying fuse),
BLACK = MINUS - Grounding terminal on the housing (maximum cable cross-section 10 mm²)
- Fuse: 250 mA, 5 x 20 mm
- Fastening possibility: a 4 mm bore
Hints and background knowledge
- Disconnect the operating voltage from the feed switch before working on the coaxial cable between the antenna and the feed switch!
Frequently, work is done on the connections of the coax cable without the 12 Volt operating voltage having been disconnected from the feed gap before. This can cause unnoticed short circuits, which can blow the 250 mA miniature fuse. In the worst case, further components within the feed gap burn *. - Do not turn the screw of the DC connection wires!
When turning the screw connection, the two connection wires may also be entangled with each other (danger of short circuit) or torn off the circuit board *.
* These damages are irreparable, the feed switch must then be replaced. - The feed-in decouples DC voltages, which come either from the 12 volt electrical system or as 5 volts from the receiver / TV.
Many DVB-T receivers or TVs provide a 5 volt DC operating voltage at the antenna connector socket to power an active 5 volt DVB-T antenna . Often, these 5 volts can be turned on or off in the basic settings.
Due to the DC decoupling no change of settings on the receiver / TV is necessary.
The advantage of the integrated amplifier is that weak antenna signals are already amplified directly in the antenna and can then be made available to the receiver / TV in a sufficiently high level.
If the amplifier is outside the antenna, weak signals could be additionally attenuated by line and line losses. If you then amplified these signals, the receiver / TV could no longer reliably separate the wanted signal from the noise (interfering frequencies), which would lead to picture and sound disturbances or to complete loss of reception.
Why a power supply via the coax cable?
Of course, an amplifier requires an operating voltage. Since it is possible to simultaneously carry the high-frequency antenna signal and a DC voltage on the coaxial cable, it saves the laying of an additional line for the operating voltage.
On board the unit is positioned in the area of the receiver / TV, as both are required: 12 Volt DC and the antenna signal.
Customers also bought
-15%
YACHTICON
AQUA CLEAN without Chlorine / powder
€22.65
from
€19
29
2 variants
-11%
SIKA
Sikaflex - 292i Marine Structural Adhesive
€18.90
only
€16
76
> 100
-15%
Ball Valve, Brass CR
€10.84
from
€9
20
8 variants
JABSCO
Check Valve / Throttle Valve
only
€11
72
> 100
SCOUT - TV / FM WAVE Antenna
only
€67
18
13
CARLINGTECH
CARLING SWITCH - Installation Frame / 1 Gang
only
€2
94
40
Stainless Steel Dual Clamp / for 25 mm tube / swivel
only
€8
36
> 100
-16%
GLOMEX
FME-PL259 Adapter for RG8X Antenna Cable
€11.00
only
€9
20
> 100
Similar items
-17%
GLOMEX
Automatic DVB-T2 Antenna Amplifier / integr. DOCK Switch
€185.00
only
€153
74
2
-40%
SHAKESPEARE
ART-3 VHF Antenna Tester
€225.25
only
€134
41
3
-16%
GLOMEX
Input Switch
€37.00
only
€31
05
15
LNA-Sea-Band VOX Antenna Booster
only
€201
64
1
-14%
GLOMEX
Antenna Splitter V9147
€22.50
only
€19
29
1
-17%
GLOMEX
Glomex 50023/14 TV Antenna Amplifier
€145.00
only
€120
97
7
Marine Balun / MLB (Magnetic Longwire Balun)
only
€127
69
4
-16%
GLOMEX
AM/FM Duplexer Splitter
€92.50
only
€77
27
28
Customers ask customers
Ask other SVB customers who have already purchased this product from us about their experience.
Your question will be automatically forwarded to other SVB customers and published on the product page. Please do not ask any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: info@svb24.com or by phone on: +49 (0)421 57290510 .
No questions asked yet. Be the first to ask a question!