Highly efficient PTFE-based thin film antifouling. Thin-film antifouling does not work by means of active ingredients that are emitted into the water, but by means of a very smooth surface, which makes it difficult for organisms to stick to.
The smooth surface is created with the addition of PTFE. The antifouling effect is also supported by the copper constituents incorporated in the binder. The extremely smooth surface ensures extremely low frictional resistance in the water and thus results in higher speeds and lower fuel consumption.
Very suitable for North and Baltic Sea and for inland waters. Not for aluminum boats; steel boats must be primed with a 2-component product (at least 350 μm). GTI 30 is ready to use and contains a high percentage of metallic copper powder. SEATEC GTI 30 is compatible with VC-17m and can be applied directly to existing old VC-17m coatings without further primers / adhesion promoters. SEATEC GTI 30 contains no chlorinated hydrocarbons. Available in graphite.
Yield approx. 11.7 m²/l with a dry film thickness of 10 μm, drying time approx. 20 min (20° C).
|Temperature||5° C / 41° F||15° C / 59° F||23° C / 73° F|
|Hand dry after||60 minutes||30 minutes||20 minutes|
|Launch after||6 hours||3 hours||2 hours|
|5° C / 41° F||16 hours|
|15° C / 59° F||10 hours|
|23° C / 73° F||6 hours|
|35° C / 95° F||4 hours|
Always read the label and product information before use.
Please note the following hazard warnings:
Customers also bought
Customers ask customers
Your question will be automatically forwarded to other SVB customers and published on the product page. Please do not ask any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: firstname.lastname@example.org or by phone on: +49 (0)421 57290510 .