The new SEATEC AEROTEND 260 yacht tender combines all the advantages of slatted bottom boats and rigid inflatable boats in to one: a stable hull, very good handling characteristics, low weight and high load capacity.
What makes the perfect yacht tender? Maximum safety, easy handling and optimum driving characteristics in any situation. While slatted bottom boats meet the requirements of simple construction, transport and storage, they also make a compromise in driving characteristics as well. Boats with solid fiberglass hulls (RIBs) provide the best handling characteristics, but because of their dimensions and heavy weight, their usage is usually limited to large yachts.
SEATEC-AEROTEND tenders connect all of these important characteristics together! This has been achieved by their entirely new high-pressure inflatable flooring systems that consist of two chambers, which are layed out in a V-shaped manner. This creates a stable, solid hull which almost reaches the capabiities seen in RIB vessels - however, with considerably lower weight, smaller packing volume and higher carrying capacities!
This special hull design guarantees high directional stability, very good steering control and less drift. The integrated transom trim plates in the stern's construction ensure optimum gliding for the boat and safe steering control around curves, even under strenuous driving conditions.
Extra wide floor slats
5 air chambers for increased safety
Flush "Halkey Roberts" - valve
2 sturdy, collapsible aluminum paddles with plastic sheaths
3 towing eyes in the bow area
3 carrying handles, two on the stern, one on the bow
2 additional carrying ropes on the inside of the stern
Dual-sided grip cord
Wooden transom with reinforcement for motor mounting
Bailer in the transom
Foot pump, carrying bag, repair kit
Type F in dark-grey/white
Towing eyes/Transport eyes
3 / no
Pack size (L x W x H)
112 x 59 x 34 cm
Max. engine power
6 kW / 8 hp
Max. engine weight
Recommended shaft length
Transom height (cm)
Note regarding the material:
The SEATEC AEROTEND yacht tenders are made of a special 5 layer PVC (polyvinyl chloride) material. The base consists of a poly fiber (polyester) fabric lining. The fabric is made of 1100 Decitex and is thus very sturdy. The fabric is lined on the interior and exterior with a so-called adhesive layer. This layer serves as a substrate for the equally double-sided PVC coating. Thanks to the PVC coating, the dinghy is airtight and sturdy. Only first-rate PVC material is used, which has specially been developed for the production of dinghies and has proven its durability for years. The material strength is approx. 0.7 mm and the boat's skin weighs about 850 g/m². The material is made in Germany. Max. tensile force is approx. 2500 N/ 5 cm.
The floor of the yacht tenders also consists of a multi-layer laminate and a spacer fabric with a strength of 67 mm. The weight of the floor is 1950 g/m² and has a maximum tensile force of 3000 N/5cm on both sides.
Ask other SVB customers who have already purchased this product from us for your experience.
Your question will be automatically forwarded to other SVB customers and your question will be published on the product page. Please do not pose any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: firstname.lastname@example.org or by phone at: +49 (0)421 57290510 .
More "Customers ask customers" available in the following languages
Pas encore gonflé l'annexe, mais il est impensable qu'il n'y ait aucune instruction de mise en œuvre, de gonflage et de pression, ni en Français ni en Anglais. Juste quelques lignes en Allemand...
Merci de m'envoyer rapidement les instructions de gonflage en Anglais