RACOR Turbine Filter / Prefilter and Water Separator
Article Number
24679
EAN
00706672004130
Max. flow rate
227
l/h
Filter fineness
30
µ
Weight
1.8
kg
Water sensor
No
Height
29.2
cm
Width
14.7
cm
Depth
12.2
cm
Fuel
Diesel
Water separator
Yes
Description
turbine filter series 500
Product details
Racor's Turbine series filters/water separators are highly efficient fuel filter systems for all types of diesel engines, satisfying customers for more than 25 years. In a three-stage system, they filter out all solids and liquid impurities (which are heavier than diesel fuels) that can cause faults. Method of operation of Racor filters/water separators as follows:
Stage 1 - Separation of solid impurities (up to 30 microns) and liquid impurities by the centrifugal action of the separator (centrifuge). At this stage, 30% of all impurities are filtered out.
Stage 2 - Collection of fine particles (up to 15 microns). Particles in a suspended state rise with the fuel into the upper part of the conical insert (cone) and collect on its inclined surfaces. The larger and heavier parts that develop over time sink to the bottom of the sight glass (bowl) to the impurities separated in the first stage.
Stage 3 - ultra-fine filtering of the fuel in the Racor replacement cartridge (insert). Separation of the remaining particles up to 2 microns (96%). Replacement cartridges are available in 10 and 30 microns. A 30 micron element serves as an initial filter in double or triple filters for pre-filtration of very poor fuel qualities. The fuel must then pass through a 10 micron element. A 10 micron element is usually used as a secondary filter and/or final stage filter for use in poor fuel qualities.
The combination of all three stages results in 100% separation of the free water (according to DIN ISO 4020).
Note: The Racor filter/water separators are designed in such a way to be installed in the suction line of the fuel feed pump. However, they can also be installed in the outlet side; in this case, the pressure must not exceed 103 kPa.
''Micron'' is the unit of measurement used to determine the size of dirt particles in liquids that are filtered with a filter.
Technical Data
Stage 1 - Separation of solid impurities (up to 30 microns) and liquid impurities by the centrifugal action of the separator (centrifuge). At this stage, 30% of all impurities are filtered out.
Stage 2 - Collection of fine particles (up to 15 microns). Particles in a suspended state rise with the fuel into the upper part of the conical insert (cone) and collect on its inclined surfaces. The larger and heavier parts that develop over time sink to the bottom of the sight glass (bowl) to the impurities separated in the first stage.
Stage 3 - ultra-fine filtering of the fuel in the Racor replacement cartridge (insert). Separation of the remaining particles up to 2 microns (96%). Replacement cartridges are available in 10 and 30 microns. A 30 micron element serves as an initial filter in double or triple filters for pre-filtration of very poor fuel qualities. The fuel must then pass through a 10 micron element. A 10 micron element is usually used as a secondary filter and/or final stage filter for use in poor fuel qualities.
The combination of all three stages results in 100% separation of the free water (according to DIN ISO 4020).
Note: The Racor filter/water separators are designed in such a way to be installed in the suction line of the fuel feed pump. However, they can also be installed in the outlet side; in this case, the pressure must not exceed 103 kPa.
''Micron'' is the unit of measurement used to determine the size of dirt particles in liquids that are filtered with a filter.
Technical Data
Series 500 turbine filter | Flow rate: 227 L/H | For engines up to approx. 300 HP |
Series 900 turbine filter | Flow rate: 341 L/H | For engines up to approx. 500 HP |
Series 1000 turbine filter | Flow rate: 681 L/H | For engines up to approx. 950 HP |
Documents
Datasheet
PDF, 6,46 MB
Spare parts
PDF, 383,81 KB
Accessories
Customers also bought
-15%
YACHTICON
AQUA CLEAN without Chlorine / powder
€22.65
from
€19
29
2 variants
Accessories for Channel Strips
from
€5
84
2 variants
CARLINGTECH
CONTURA V Switch Panel
from
€4
16
14 variants
End Piece for Pipes / stainless steel
from
€8
36
3 variants
CARLINGTECH
CARLING SWITCH - Installation Frame / 3 Gan
only
€8
36
37
RACOR
Replacement Filter for 500 Series Turbine Filter
from
€11
72
2 variants
Ball Head for Control Cables
only
€6
68
9
Cable Clamp for Control Cable
only
€5
84
76
BLUE SEA
Waterproof Contura Switchboard, 4-Section / black
only
€161
30
3
SCANSTRUT
ROKK EDGE QI Wireless Charger
only
€201
64
2
BOSCH
Power Relay
from
€54
58
2 variants
Similar items
-11%
RACOR
SPIN-ON 230 Fuel Pre-filter and Water Separator / 30 microns
€197.13
only
€176
43
3
RACOR
SPIN-ON 120 Fuel Pre-filter and Water Separator / 30 microns
only
€176
05
4
-28%
RACOR
Dual Turbine Filter / Prefilter and Water Separator
€3,063.82
from
€2.201
64
3 variants
RACOR
SPIN-ON Petrol Pre-Filter / 300 Series
only
€150
84
2
RACOR
SPIN-ON Petrol Pre-Filter/ Series 100
only
€156
26
2
RACOR
SNAPP Filter System / 30 Microns
only
€105
84
12
RACOR
SNAPP Filter System / 10 Microns
only
€105
00
9
Combination Filter 2-1 Prefilter & Water Separator Type CAV / 50 LPH
only
€117
61
8
-16%
Prefilter & Water Separator Type CAV FLOW 90S / with Water Sensor / up to 272 HP
€150.00
only
€126
01
4
-26%
Prefilter & Water Separator Type CAV FLOW 90 / up to 272 HP
€108.00
only
€79
79
5
Customers ask customers
Ask other SVB customers who have already purchased this product from us about their experience.
Your question will be automatically forwarded to other SVB customers and published on the product page. Please do not ask any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: info@svb24.com or by phone on: +49 (0)421 57290510 .
No questions asked yet. Be the first to ask a question!