FLYWEIGHT PREMIUM Solar Module Kit / 120 W

This foldable solar module with charge regulator impresses with its high energy yield, low weight and ability to fit into small spaces.

Folded up in the textile frame, this module is an inconspicuous companion, which is quickly ready for use. The textile module carrier features riveted eyelets, which can be used to fix the module in place, e.g.. with a rubber cord or ratline. Of course, the module can very easily be laid out. In addition, it has installation supports which are held on the module support by Velcro straps when not in use and with the help of which the module can also be aligned to low sunlight.
In the outer compartment of the textile module carrier, there are the ready-wired module connections with approx. 4.5 m cable, the PHOCOS CMLup 10 solar controller and approx. 1.4 m battery connection cable with adapter plug connection. Matching the adapter plug connection and also included in delivery: three approx. 1 m long adapter cables with alligator clips, ring cable lugs (5 mm inner Ø) and cigarette lighter plug. The cigarette lighter plug features a 10 A micro fuse. Length of the battery connection cable incl. regulator and adapter cable approx. 7 m. The controller's 5 V USB output can be used to power mobile devices such as smartphones, tablets, cameras, etc.

Technical data:

System voltage	12 V
Nominal output	120 W (3x 40 W)
Voltage at max. power (Vmp)	19.8 V
Current at max. power (Imp)	6.1 A
Open circuit voltage (Uoc)	23.7 V
Short circuit voltage (Isc)	6.6 A
Cell / cell efficiency	3x 12 mono / 21.3 %
Operating temperature	-40 °C to +85 °C
Frame	Textile
Module/battery/adapter cable	Approx. 4000 mm / 1500 mm / 1000 mm - 14 AWG / approx. 2.5 mm²
Unfolded dimensions	1280 x 540 x 10 mm
Folded dimensions	540 x 410 x 20 mm
Weight	2.9 kg
Charge controller type / system voltage / max. solar power	PWM with LCD display / 12 V DC / 10 A
USB charge controller output power	5 V DC / 1500 mA
Certifications	CE, RoHS

Notes

• When using an alligator clip adapter or ring cable lug adapter, we also recommend fitting a 10 A fuse close to the battery (max. 20 cm).
  Fuse holders and micro fuse holders are optionally available.
• Although the PHOCOS MLPup controller used is capable of detecting 12 or 24 volt battery systems, the module can only be used in 12 volt on-board systems due to the 17.6 Vmp output voltage.
• The controller is not splash-proof and must therefore be stored in a dry environment!
• Further technical data of the controller can be found within the operating instructions.
  The instructions can be found in the documents below.
• Please observe the instructions in the operation manual!