MASTERVOLT MAC PLUS DC-DC CHARGER 12V to 12V / 50A

Only 1 in stock
pcs.
SVB price: €504.16
You save: 8%
€550.00
Excl. VAT, excl. shipping costs.
This is a NET-price excluding German VAT. Shipments to countries outside of the EU may be subject to import duties and taxes.
pcs.
€504.16 This is a NET-price excluding German VAT. Shipments to countries outside of the EU may be subject to import duties and taxes.
Buy
Available variants:
Image of MAC PLUS Battery to Battery Charger 24V to 12V / 50A

MASTERVOLT MAC PLUS Battery to Battery Charger 24V to 12V / 50A

Your battery's best friend. MASTERVOLT's MAC PLUS DC-DC converters guarantee optimal condition of your service battery.

Image of MAC PLUS Battery to Battery Charger 24V to 24V / 30A

MASTERVOLT MAC PLUS Battery to Battery Charger 24V to 24V / 30A

Your battery's best friend. MASTERVOLT's MAC PLUS DC-DC converters guarantee optimal condition of your service battery.

Image of MAC PLUS DC-DC CHARGER 12V to 24V / 30A

MASTERVOLT MAC PLUS DC-DC CHARGER 12V to 24V / 30A

Your battery's best friend. MASTERVOLT's MAC PLUS DC-DC converters guarantee optimal condition of your service battery.

Item no.
65597
EAN
00816882021374
Model no.
81205100
Type
MASTERVOLT - MAC PLUS 12/12-50
Input
10 - 16 V
Output
12 V
Current
50 A

Product details

Charging service batteries on board of a vehicle or vessel can be challenging. Recharging tends to take a long time and batteries may not receive a full charge. This is a common problem found in boats and caravans.

The robust MASTERVOLT DC-DC charger guarantees optimal condition of your service battery at all times.

Traditionally, a service battery is linked to the starter battery by means of a charge relay. The starter battery is located close to the alternator and receives most of the charge current. However, the service battery is usually further away. Long cables cause voltage drops, leading to slow charging, resulting in failing appliances and premature failure of the battery.

Modern, fuel efficient engines are equipped with smart alternators, following regulations such as Euro 5 and Euro 6. Instead of a constant output, smart alternators provide a variable voltage; after a brief charging period, voltage is reduced and the charging stops. Furthermore, the energy produced by regenerative braking leads to voltage peaks. Service batteries coupled in the traditional way will receive hardly any charge and may be damaged by these peak voltages.

To solve these issues, Mastervolt introduces the Mac Plus DC-DC chargers, available in 12 V or 24 V. The Mac Plus monitors the service battery and compensates the voltage loss. The proven 3-step charge method ensures a quick and safe charge. Moreover, by stabilizing the charge voltage, Mac Plus protects your service battery and sensitive equipment.

The Mac Plus is your battery’s best friend. It monitors your service battery and makes sure it’s always fully charged, maximising the lifetime of your battery.

Features:
  • Fast and safe charging during short trips.
  • Fanless design for silent operation.
  • Suitable for flooded, Gel, AGM and Li-Ion batteries (incl. LiFePO4).
  • Charges even fully depleted batteries.
  • Engine run detection protects starter battery.
  • Adjustable current limits to meet Euro 5/6 requirements.
  • Voltage stabilisation protects sensitive equipment, lights and loads.
  • Parallel operation to obtain charging capacities well over 100 Amps.
  • MasterBus for intelligent system monitoring and automation.
  • Temperature compensation and voltage sense for an optimal charging result.
  • E-mark certification for mobile applications.
  • Power supply mode.
  • Heavy duty connections for easy installation and quick set up via DIP switches.

Applications
Boost charge voltage when service battery is located further from charging source or in systems with a smart alternator.
When a stable power supply or different system voltage is needed.

Correct charging with intelligent alternators
The Mac Plus provides constant power to the service battery, even when the alternator is inactive.

Programmable via desktop or laptop or PC
Remote control the MAC PLUS via your laptop or PC or configure your personal preferences. The device has a communication port and easy installation with a PC-Link and MasterAdjust software.

Parallel operation
The parallel configuration of several units will provide you with over 100 amperes. Advanced high-frequency technology with modern microprocessors ensures minimum power loss when switching from 24 to 12 V and vice versa.


Specifications
Item number 65597
Name MAC PLUS 12/12-50
Battery charger specifications
Battery temperature sensor Yes, included
Battery voltage sense Yes
General Specifications
Status indicator Yes, 3-colour LED
Output voltage 10-15 V
Nominal output voltage 12 V
Output voltage stabilisation 2% at extreme temperatures, load and input
Ripple output voltage (peak peak) Max. 1 %
Max. output power 725 W
Nominal output power 675 W
Max. Output current 50 A
Output charge current (3-step mode) 50 A
Nominal input voltage 12 V
Input voltage range 10-16 V
Max. input current 50 A
Galvanic isolation No
Voltage limited Yes
Efficiency 95% (at nom. input voltage, full load); peak 97%
Parallel configuration Yes
Alarm contact Yes, through MasterBus
Power supply via MasterBus No
Engine run signal input Yes (active high/active low)
Dip switch Yes, for basic setup
Dimensions, HxWxD 255 x 165 x 66 mm
10.0 x 6.5 x 2.6 inch
Weight: 2 kg
4.4 lb
Certifications CE, E mark
Technical Specifications
No-load consumption
Charge characteristic 3-step+
Battery types Flooded, gel, AGM, spiral, Lithium Ion, traction, user defined
3-step charge option Yes (DIP switch settings)
DC power consumption < 5 mA
Connectors 3 x M8 terminal for cable diameters of 10-50 mm², (positive input, positive output, joint negative connection) 8-pole screw connection for cable diameters of 0.75-1.5 mm² (remote on/off, temperature sensor, voltage measurement)
Temperature range (ambient temp.) -25°C to 60°C; derating > 40°C
-13°F to 140°F
Level of protection IP23
Protection systems DC short circuit, overload, over temperature, high/low battery voltage, reversed polarity (fuse)
Cooling Natural cooling
MasterBus compatible Yes
Delivery contents 1x temperature sensor with 6 m cable, 1x master bus terminating resistor (terminator)




Delivery contents

  • DC - DC converter
  • Terminating resistor
  • Temperature sensor
  • Instructions

Documents

en-flag Certificate
PDF, 914,32 KB
Item no.: 65597,65598,65599,65600
en-flag Manual
PDF, 2,49 MB
multi-flag Certificate
PDF, 72,32 KB
multi-flag Drawing
PDF, 182,25 KB
de-flag Manual
PDF, 1,14 MB

What other SVB customers have to say

100% real reviews
Nobody has rated this product yet

Comparison with other products

1
This product
2
3
4
Item no.
65597
65598
65600
65599
Customer ratings
No rating yet
No rating yet
No rating yet
No rating yet
Output
12 V
24 V
24 V
24 V
Input
10 - 16 V
19 - 30 V
19 - 30 V
10 - 16 V
Current
50 A
50 A
30 A
30 A
Type
MASTERVOLT - MAC PLUS 12/12-50
MASTERVOLT - MAC PLUS 24/12-50
MASTERVOLT - MAC PLUS 24/24-30
MASTERVOLT - MAC PLUS 12/24-30
Availability / Price
Only 1 in stock
only €504 16
Buy now
Available within 2-3 weeks
only €504 16
Buy now
Only 2 in stock
only €504 16
Buy now
Available on 01.04.2024
only €504 16
Buy now

Customers ask customers

Ask other SVB customers who have already purchased this product from us about their experience.

Your question will be automatically forwarded to other SVB customers and published on the product page. Please do not ask any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: info@svb24.com or by phone on: +49 (0)421 57290510 .

  • More "Customers ask customers" available in the following languages :
  • Flag of Deutsch

Technical question

Question:
User image of Artemiy K.
Artemiy K. asked
on Jul 28, 2023
Flag of English Hello! Will you please provide information on size of fuse to be used for positive in/out connection for this charger? I haven't seen this information in the manual. Also, how one can set the Lithium profile for the charger, are DIP switch is enough or I will need something extra? Thank you!
No answers yet. Be the first to answer this question!