Continuous load capacity (1 hour): 70 A @ 12 & 24 V / 60 A @ 36 & 48 V
Connections: Screw terminals for 10 & 16 mm² cables (2 allen screws per terminal)
Total length: 90 mm
Housing length: 73 mm
Max. diameter: 44 mm
Diameter x length:
Receptacle & mounting plate dimensions
Front ring diameter x length: 50.5 x 60 mm
Required installation opening: approx. 44 mm Ø
Max. wall thickness when installed with lock nut: approx. 22 mm
Outer diameter lock nut: 60 mm
Mounting plate dimensions: 76 x 57 x 6 mm
Mounting plate hole spacing & bore Ø: 64 / 4 mm
Ordinary 3-wire cable with a common sheath will not fit through the cable entry of this connector.
Instead, only two or three individual single-core cables with a conductor cross-section of between 10 and 16 mm² will fit.
The total diameter of a single-core 16 mm² cable is approx. 7 mm.
At the end of the connector, the 2 or 3 single-core cables are routed side by side through a strain relief.
When using 2 single-core cables, these should not exceed a total diameter of approx. 9 mm, when connecting 3 cables, only 7.1 mm each, as the cables will lie directly next to each other in the 21.5 mm wide strain relief.
The cables are fed into the connector through a thin flexible seal. The seal already has openings for 2 wires. If a third wire is to be connected, the seal must be pierced at the marked point with a pointed tool.
Customers also bought
Customers ask customers
Your question will be automatically forwarded to other SVB customers and published on the product page. Please do not ask any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: firstname.lastname@example.org or by phone on: +49 (0)421 57290510 .