SVB recommends the following for these items
- Theoretical yield: 12 m²/l.
- Processing temperature: +10° C to +30° C
- Drying time at 20 °C: 4 hours
- Overcoating time at 20 °C: min. 5 hours
For uncoated surfaces: Remove salts, detergents, dirt and marine growth using a high-pressure cleaner. Prime the prepared surface with LIGHT PRIMER and then, while the primer is still tacky, coat with UNDERWATER PRIMER to act as an adhesion facilitator.
For coated surfaces: Remove fouling and impurities using a high-pressure cleaner. In case of unknown antifouling, wet sand the substrate and remove dust. If the previous antifouling layer is in poor condition, seal the area to be treated with UNDERWATER PRIMER. If the condition of the previous coating is bad all round, it is recommended to remove it and then start a new layering process (see above).
Use on GRP, wood and steel/lead: Every 12 months, apply two coats to the surface to be treated. At the waterline and on heavily used areas of the underwater hull, apply a further coat. For Sweden, Finland, Netherlands apply only one coat of antifouling.
Do not apply to aluminium or other light alloys.
Handle with care. Before and during application, all safety instructions on the packaging and containers, the safety data sheets prepared by HEMPEL and local or national safety regulations must be followed.
Please note the following hazard warnings:
Customers also bought
Customers ask customers
Your question will be automatically forwarded to other SVB customers and published on the product page. Please do not ask any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: firstname.lastname@example.org or by phone on: +49 (0)421 57290510 .