- Protect your boat with sacrificial anodes -
Sacrificial anodes are metals or alloys that have a more anodic, i.e. less noble, potential than steel and are used against corrosion. The less noble material of the anode "sacrifices" itself and dissolves, thus protecting the hull and the parts of the boat that are susceptible to corrosion. If the anodes don't show any signs of dissolving after a while, something might be wrong. Something is always getting dissolved. If the sacrificial anodes are not attacked by corrosion, another area is probaly affected by corrosion.
Anodes are mounted along the keel. The electric current is higher at the stern post due to the propeller being located there. It is advisable to install several anodes in this area. Anodes should also be mounted on the rudder and propeller shaft.
Typically, anodes have to be replaced once per season. In harsh water conditions, a more frequent replacement schedule might be necessary.
For the protection of hulls, engines and outboard motors made from aluminium alloys, zinc anodes are commonly used in salt- and brackish water. In fresh water conditions, magnesium anodes are commonly used. For hulls and other underwater parts made from steel, brass or bronze, zinc anodes may be used. However, they tend to be replaced more frequently than aluminium anodes due to the fact that zinc anodes always contain a small percentage of the toxic heavy metal cadmium. This is also why aluminium anodes are considered to be a lot more environmentally friendly. Moreover, aluminium anodes are more efficient, longer-lasting and recommended for usage in brackish waters or when going back and forth between salt and freshwater.
Anodes must never be painted or lubricated! This is because they would lose their electrical conductivity with water and thus, they will not be able to properly prevent corrosion. If a boat stays on land for a long period of time, some layers of oxidation (especially in the case of aluminium anodes) might prevent them from functioning properly, as the potential difference might be too low.
Metal surfaces in m2 / zinc anodes in kg
5 to 10 m2 / 5.5 kg
10 to 20 m2 / 9.5 kg
20 to 30 m2 / 18.0 kg
30 to 40 m2 / 20.0 kg
40 to 50 m2 / 25.0 kg
Wojciech Z. on 26.02.2024
I'm very satisfied .As usually since many years.
Martyn C. on 26.02.2024
Everything arrived on time and perfectly packaged. A job well done and communication was excellent
Alexandra B. on 26.02.2024
Excellent communication with customer service, items were sent quickly (if something isnt in stock Ive been notified about delivery time which is very helpful ). Everything was good, Id gladly order again!